FANUC Alarm PTPG-000 — Paint Plug-In internal error
FANUC PTPG-000 (“Paint Plug-In internal error”): This error is caused when a internal problem has occurred within the Paint Plug In software. First check: Write down the exact error number and message shown.
Updated 2026-09-17 · LogrobotLM reference
Description
This error is caused when a internal problem has occurred within the Paint Plug In software. This fault is almost always caused by style paths which do things which were not anticipated when this software was written. The reasons for this could be: 1. The path is too fast 2. The instructions (PPS and PPE) are too close together 3. The delay and timing values specified in your Paint Plug In Setup are too large or do not make sense. 4. Your robot's CPU has failed.
Remedy
Write down the exact error number and message shown. Write down exactly what your robot was doing at the time of the failure. Make sure you include: Program name, line number, robot's location in the work cell, any cell I/O or other communciation activity, and exactly what the robot was doing right before the fault occured. This fault is usually fixed by doing a COLD start. If that does not work, contact your supervisor or call the FANUC or FANUC Robotics Hot Line.
Related codes
Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. How this reference is built →