ABB Error 0114 — Enabling chain fault
ErrorABB 0114 (“Enabling chain fault”): Hardware error during the self-test of the enable chain (safety stop circuit). Likely part: DSQC 211 (enabling chain).
Updated 2026-10-22 · LogrobotLM reference
What it means
Hardware error during the self-test of the enable chain (safety stop circuit).
What to check
- A Replace the computer board.
- B Replace the DSQC 211 power supply unit.
- C Replace the backplane.
- Note: Will become the cabinet power supply or drive contactor board faults.
Part to check / replace
ABB 0114 points to the hardware below — start here before ordering.
Tap a part for every code that points to it — and verify the exact variant for your controller before ordering.
Related codes
Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. How this reference is built →