LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free →

FANUC Alarm BELL-033 — WARN … overspeed

Manufacturer wording — WARN %s overspeed
The manual prints placeholders; your controller fills them in with the real group, axis or number.

FANUC BELL-033 (“WARN … overspeed”): The indicated axis will exceed it’s maximum speed limit. First check: Increase the conveyor position relative to the previous points conveyor position or decrease the change in axis position relative to the previous points axis position.

Updated 2026-09-17 · LogrobotLM reference

Description

The indicated axis will exceed it’s maximum speed limit.

Remedy

Increase the conveyor position relative to the previous points conveyor position or decrease the change in axis position relative to the previous points axis position. In the case of a top ma chine, the maximum conveyor speed can be reduced.

Related codes

BELL-031WARN Non-increasing fluid zonesBELL-032WARN Non-increasing trigger zonesBELL-034WARN Can't find min pnt spdBELL-035WARN Can't optimize max pnt spd

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. How this reference is built →