LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free →

FANUC Alarm BELL-108 — WARN 2nd posn must be paint-on

FANUC BELL-108 (“WARN 2nd posn must be paint-on”): The second position in the job has the paint mode set false. First check: Change the paint mode of the second position to ON.

Updated 2026-09-17 · LogrobotLM reference

Description

The second position in the job has the paint mode set false. Motion to the second position must always be a paint motion.

Remedy

Change the paint mode of the second position to ON.

Related codes

BELL-106WARN Job does not existBELL-107WARN 1st posn must be non-paintBELL-109WARN Non-increasing conveyor valuesBELL-110WARN Max conveyor speed is too small

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. How this reference is built →