LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free →

FANUC Alarm DNET-112 — WARN Board not ready; pls. wait

FANUC DNET-112 (“WARN Board not ready; pls. wait”): An attempt to bring the board on-line was unsuccessful because the board was busy. First check: Wait ten seconds and re-attempt to bring the board on-line.

Updated 2026-09-17 · LogrobotLM reference

Description

An attempt to bring the board on-line was unsuccessful because the board was busy.

Remedy

Wait ten seconds and re-attempt to bring the board on-line. If the problem persists, check board connection to the network, baud rate, and network power.

Related codes

DNET-110WARN Error: board scanningDNET-111WARN Error: board not scanningDNET-113WARN OFFSET cmd err ret ' caused by boardDNET-114WARN Bus fault error detected

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. How this reference is built →