LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free →

FANUC Alarm PAIN-268 — WARN Scale Calibration Aborted

FANUC PAIN-268 (“WARN Scale Calibration Aborted”): The scale calibration sequence did not complete. First check: N/A

Updated 2026-09-17 · LogrobotLM reference

Description

The scale calibration sequence did not complete. Can be dby timeout or fill/empty error.: Check the alarm log to see what conditions d the calibration to abort. In most cases, the scale cal can timeout from one of the following alarms: PAIN-253 Beaker timeout, scale cal abort,PAIN248, CC abort, can full timeout, PAIN-249 CC abort, can empty timeout. Verify all equipment is operation properly.See other alarm /.

Remedy

N/A

Related codes

PAIN-266WARN Flow Error High, Valve: …PAIN-267WARN Applicator Disabled during jobPAIN-269WARN Scale Calibration SuccessfulPAIN-270WARN …Cal. table adapted out tolerance

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. How this reference is built →