LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free →

FANUC Alarm PAIN-435 — WARN …Calibration aborted

Manufacturer wording — WARN %sCalibration aborted
The manual prints placeholders; your controller fills them in with the real group, axis or number.

FANUC PAIN-435 (“WARN …Calibration aborted”): Accuflow calibration could not continue. First check: The best may be found from the previous alarm in the log.

Updated 2026-09-17 · LogrobotLM reference

Description

Accuflow calibration could not continue. This may be due to the fluid lines not being filled. Check for other alarms in the log.

Remedy

The best may be found from the previous alarm in the log. This is usually the result of

Related codes

PAIN-433WARN …Flow rate average error highPAIN-434WARN …Calibration successfulPAIN-436WARN …Cal. low flow rate resetPAIN-437WARN …Cal. max. flow rate reset

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. How this reference is built →