LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free →

FANUC Alarm PALL-190 — .VR file has not been created

FANUC PALL-190 (“.VR file has not been created”): During the transfer of data from the PC, the.VR data file could not be created. First check: Check the available memory.

Updated 2026-09-17 · LogrobotLM reference

Description

During the transfer of data from the PC, the.VR data file could not be created.

Remedy

Check the available memory. If RAM is full, clear the unneeded data and try again.

Related codes

PALL-188Palletizing:STEP mode not allowedPALL-189Unit load data error.PALL-191TEMP DRAM memory is lowPALL-192Cannot CALC; TEMP memory low

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. How this reference is built →