LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free → · Le diagnostic IA qui lit la sauvegarde de votre robot, sans rien téléverser.

FANUC Alarm PNT1-601 — %sFast fluid flow leak detected

Description

A large amount of fluid flow was detected when the gun was not turned on. This might be caused by the dump valve being stuck on, or a broken fitting, or a broken paint line. Note that each time the fluid begins to leak fast, the color valve will be turned off. This will prevent the robot from spraying the part.

Remedy · Remède

The various fluid lines and valves should be inspected and repaired immediately. Check and repair the dump pilot valve and the dump valve, if necessary.

Related codes / Codes liés

PNT1-599%sRequested flow above cal. tablePNT1-600%sSlow fluid flow leak detectedPNT1-602%sFailed to reach setpointPNT1-603%sAccuflow softpart init Failed

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. · Informations indicatives issues du terrain — le manuel du constructeur et ses procédures de sécurité font foi. Ne shuntez jamais un organe de sécurité ; consignez (LOTO) avant toute intervention physique.