LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free →

FANUC Alarm PNT1-724 — Turbine under speed warning

Manufacturer wording — %sTurbine under speed warning
The manual prints placeholders; your controller fills them in with the real group, axis or number.

FANUC PNT1-724 (“Turbine under speed warning”): While the gun was off or disabled and the turbine was operating the RPM level was below the Under speed limit, Manual. First check: N/A

Updated 2026-09-17 · LogrobotLM reference

Description

While the gun was off or disabled and the turbine was operating the RPM level was below the Under speed limit, Manual. Check and replace the I/P transducer if necessary. Check the supply and pilot air pressures, if either one is low, increase it. Possibly decrease the Under speed limit, Manual value.

Remedy

N/A

Related codes

PNT1-722Turbine over speedPNT1-723Turbine under speed faultPNT1-725Speed avg. error excessivePNT1-726Bearing Air NOT OK

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. How this reference is built →