LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free →

FANUC Alarm PNT2-619 — Cal. max. flow rate reset

Manufacturer wording — %sCal. max. flow rate reset
The manual prints placeholders; your controller fills them in with the real group, axis or number.

FANUC PNT2-619 (“Cal. max. flow rate reset”): This is a warning, not a failure. First check: The new maximum flow rate is shown as point 10 in the calibration table.

Updated 2026-09-17 · LogrobotLM reference

Description

This is a warning, not a failure. During AccuAir calibration the expected maximum flow rate could not be reached at the maximum output. A new maximum flow rate was established.

Remedy

The new maximum flow rate is shown as point 10 in the calibration table. This value can be visually checked and accepted.

Related codes

PNT2-617Calibration abortedPNT2-618Cal. low flow rate resetPNT2-620Cal. time out at max. flowPNT2-621Cal. time out at low flow

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. How this reference is built →