LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free →

FANUC Alarm PRIO-330 — CC-LK PNTtoUOP not enough

Manufacturer wording — CC-LK PNTtoUOP not enough(%d)
The manual prints placeholders; your controller fills them in with the real group, axis or number.

FANUC PRIO-330 (“CC-LK PNTtoUOP not enough”): The number of points of RX/RY to be assigned to UOP are not enough. First check: Change the Number of Stations on the CC-Link SETUP screen.

Updated 2026-09-17 · LogrobotLM reference

Description

The number of points of RX/RY to be assigned to UOP are not enough.

Remedy

Change the Number of Stations on the CC-Link SETUP screen.

Related codes

PRIO-328CC-LK AO/R too manyPRIO-329CC-LK AI/R too manyPRIO-331CC-LK Reg data invalidPRIO-332CC-LK no comm. to master

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. How this reference is built →