FANUC Alarm SEAL-008 — STOP System call failed
FANUC SEAL-008 (“STOP System call failed”): This error is d when Dispensetool encounters a problem it is unable to solve internally. First check: Write down the exact error number and message shown.
Updated 2026-09-17 · LogrobotLM reference
Description
This error is d when Dispensetool encounters a problem it is unable to solve internally. This fault is almost always caused by style paths which do things which were not anticipated when this software was written. The reasons for this could be: 1. The sealing path is too fast 2. The sealing instructions (SS and SE) are too close together 3. The delay and timing values specified in your sealing schedules are too large or do not make sense. 4. Your robot's CPU has failed
Remedy
Write down the exact error number and message shown. Write down exactly what your robot was doing at the time of the failure. Make sure you include: Program name, line number, robot's location in the work cell, any cell I/O or other communciation activity, and exactly what the robot was doing right before the fault occured. This fault is usually fixed by doing a COLD start. If that does not work, contact your supervisor or call the FANUC robotics Hot Line.
Related codes
Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. How this reference is built →