LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free →

FANUC Alarm SEAL-060 — WARN High pressure (E…)

Manufacturer wording — WARN High pressure (E%d)
The manual prints placeholders; your controller fills them in with the real group, axis or number.

FANUC SEAL-060 (“WARN High pressure (E…)”): The high pressure signal(DI) has been on for the configured time during sealing. First check: Check the sealing equipment high pressure signal, disable the check for the high pressure signal, or set the timeout value for a longer period

Updated 2026-09-17 · LogrobotLM reference

Description

The high pressure signal(DI) has been on for the configured time during sealing.

Remedy

Check the sealing equipment high pressure signal, disable the check for the high pressure signal, or set the timeout value for a longer period

Related codes

SEAL-058WARN Flow rate fault (E…)SEAL-059WARN Not calibrated warning (E…)SEAL-061WARN Seal not readySEAL-062WARN Reload fault (E…)

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. How this reference is built →