LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free →

FANUC Alarm SEAL-115 — WARN No material flow (E…)

Manufacturer wording — WARN No material flow (E%d)
The manual prints placeholders; your controller fills them in with the real group, axis or number.

FANUC SEAL-115 (“WARN No material flow (E…)”): The dispenser has detected a abnormally low or high material flow rate. First check: See the dispensing equipment manual for more information.

Updated 2026-09-17 · LogrobotLM reference

Description

The dispenser has detected a abnormally low or high material flow rate. This could be caused by a plugged gun.

Remedy

See the dispensing equipment manual for more information. You could try cleaning and purging the gun.

Related codes

SEAL-113WARN I/O config incomplete (E…)SEAL-114WARN Dispenser not ready (E…)SEAL-116WARN Flow command too lowSEAL-117WARN System/drive not ready (E…)

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. How this reference is built →