LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free →

FANUC Alarm SEAL-273 — WARN Channel 2 analog is above set point (E…)

Manufacturer wording — WARN Channel 2 analog is above set point (E%d)
The manual prints placeholders; your controller fills them in with the real group, axis or number.

FANUC SEAL-273 (“WARN Channel 2 analog is above set point (E…)”): This error is reported when the computed Channel 2 analog is great than the user specified (or calibrated) maximum Channel 2 analog output, which is specified under the equipment setup. First check: Refer to dispensing equipment for fault details.

Updated 2026-09-17 · LogrobotLM reference

Description

This error is reported when the computed Channel 2 analog is great than the user specified (or calibrated) maximum Channel 2 analog output, which is specified under the equipment setup.

Remedy

Refer to dispensing equipment for fault details.

Related codes

SEAL-271WARN Channel 2 analog is zero (E…)SEAL-272WARN Channel 2 analog is below set point (E…)SEAL-274WARN Dispenser not pressurized (E…)SEAL-275WARN Dispenser meter not full (E…)

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. How this reference is built →