LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free → · Le diagnostic IA qui lit la sauvegarde de votre robot, sans rien téléverser.

FANUC Alarm SPOT-303 — %s

Description

This message is posted to identify a spot that executed while weld simulation was active. The message will look like: SPOT-303: SimWld (Progname,Line#). Note that this message is only posted if $spotcofig.$weld_sim = TRUE, and $spotcofig.$sim_warn = TRUE

Remedy · Remède

Set $spotcofig.$sim_warn = FALSE, to simulate welds without the SPOT-303 warning. Set $spotcofig.$sim_enb = FALSE, to disable weld simulation, and the SPOT-303 warning.

Related codes / Codes liés

SPOT-301Weld enabled during spot simSPOT-302Weld sim DisabledSPOT-304Stroke disabled during weld retry %sSPOT-306Found duplicate model

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. · Informations indicatives issues du terrain — le manuel du constructeur et ses procédures de sécurité font foi. Ne shuntez jamais un organe de sécurité ; consignez (LOTO) avant toute intervention physique.