LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free →

FANUC Alarm SSPC-103 — STOP is near to target

Manufacturer wording — STOP (G:%d) is near to target
The manual prints placeholders; your controller fills them in with the real group, axis or number.

FANUC SSPC-103 (“STOP is near to target”): Interaction is detected. First check: You can reset the alarm with SHIFT+RESET and can jog the robot to the out of the interacted area.

Updated 2026-09-17 · LogrobotLM reference

Description

Interaction is detected.

Remedy

You can reset the alarm with SHIFT+RESET and can jog the robot to the out of the interacted area. This key operation disable the interaction check temporarily while the SHIFT key is being pressed.

Related codes

SSPC-101SERVO is close to targetSSPC-102STOP is close to target(qstop)SSPC-104SYSTEM APDT error …SSPC-105SERVO Too many settings

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. How this reference is built →