LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free →

FANUC Alarm SVGN-035 — STOP Pressure enable time out

FANUC SVGN-035 (“STOP Pressure enable time out”): Pressure enable signal has not input after time out. First check: Check the reason of pressure enable signal off.

Updated 2026-09-17 · LogrobotLM reference

Description

Pressure enable signal has not input after time out.

Remedy

Check the reason of pressure enable signal off. Or Fix the value of time out($SPOTEQSETUP[1].$PEN_TMOUT).

Related codes

SVGN-033STOP Tip increased error(Robot)SVGN-034STOP Excessive robot tip difference.SVGN-036STOP Comp confirmation time outSVGN-037STOP Illegal pressure enable signal

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. How this reference is built →