LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free →

ABB Error 50362 — Axis / brake motor fault

Error

ABB 50362 (“Axis / brake motor fault”): The affected axis did not reach its setpoint position after the brake release delay. Likely part: Axe / Frein moteur (axis / brake motor).

Updated 2026-10-22 · LogrobotLM reference

What it means

The affected axis did not reach its setpoint position after the brake release delay.

What to check

  • Check the 24V brake release supply.
  • Inspect the robot axis brake cable.
  • Note: Physical brake release fault on robot axes.

Part to check / replace

ABB 50362 points to the hardware below — start here before ordering.

Tap a part for every code that points to it — and verify the exact variant for your controller before ordering.

Related codes

50021Axis servo control / Feedback / Mechanics fault50052Joint speed too high50055Joint load high

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. How this reference is built →