ABB Error 71362 — I/O signal mapped outside the I/O device data area
ErrorABB 71362 (“I/O signal mapped outside the I/O device data area”): I/O signal mapped outside the I/O device data area: an I/O signal is mapped beyond the data area declared for the unit. Likely part: Unité d'E/S / Mappage de signal (Unité d'E/S / Mappage de signal).
Updated 2026-10-22 · LogrobotLM reference
What it means
I/O signal mapped outside the I/O device data area: an I/O signal is mapped beyond the data area declared for the unit. Encountered on fieldbus modules (PROFINET IO, EtherNet/IP, DeviceNet).
What to check
- Compare the size of the data area declared for the unit (Connection Input/Output Size parameters) with the actual signal mapping.
- Correct the address of the out-of-range signal or increase the declared size.
- Check that the configuration file actually matches the physically installed module.
- Note: Configuration error, not a component error, but it appears as a block at the end of the Elog at start-up and often masks the real I/O hardware errors (71367, 71424).
Part to check / replace
ABB 71362 points to the hardware below — start here before ordering.
Tap a part for every code that points to it — and verify the exact variant for your controller before ordering.
Related codes
Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. How this reference is built →