LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free →

FANUC Alarm CVIS-038 — Too many candidates to process.

FANUC CVIS-038 (“Too many candidates to process.”): There is not enough memory to perform the detection with the specified condition. First check: In the Geometric Pattern Match (GPM) Tool SETUP screen, check if you have the Orientation, Scale, or Aspect Ratio degrees of freedom enabled.

Updated 2026-09-17 · LogrobotLM reference

Description

There is not enough memory to perform the detection with the specified condition. The image has too many candidate patterns to find.

Remedy

In the Geometric Pattern Match (GPM) Tool SETUP screen, check if you have the Orientation, Scale, or Aspect Ratio degrees of freedom enabled. If so, reduce the maximums and/or increase the minimums and try to find again. If it still fails, disable one or more degrees of freedom. Make the following adjustments to reduce the search candidates:

Related codes

CVIS-036The emphasis area is too small.CVIS-037The model pattern is not symmetrical.CVIS-039The mask doesn't fit the model pattern.CVIS-040The mask doesn't fit the search window.

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. How this reference is built →