LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free →

FANUC Alarm CVIS-169 — Object is not found in some camera view(s).

FANUC CVIS-169 (“Object is not found in some camera view(s).”): The offset cannot be computed because the object is not found in some camera views. First check: Modify parameters to find the object properly, then click Snap+Find to find the object.

Updated 2026-09-17 · LogrobotLM reference

Description

The offset cannot be computed because the object is not found in some camera views.

Remedy

Modify parameters to find the object properly, then click Snap+Find to find the object.

Related codes

CVIS-167Target Controller is too old to communicateCVIS-168Target Controller is off-lineCVIS-170Combine error exceed the limit.CVIS-171Calibration must be perspective.

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. How this reference is built →