LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free →

FANUC Alarm CVIS-350 — Initial measurement position is not set.

FANUC CVIS-350 (“Initial measurement position is not set.”): Initial measurement position is not set. First check: Set an initial measrement position into the data of Robot-Generated Grid Calibration Tool.

Updated 2026-09-17 · LogrobotLM reference

Description

Initial measurement position is not set.

Remedy

Set an initial measrement position into the data of Robot-Generated Grid Calibration Tool.

Related codes

CVIS-348The camera that is connected to other controller is not supported.CVIS-349Too long string.CVIS-351Invalid motion group number.CVIS-352The two found positions are too close.

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. How this reference is built →