LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free → · Le diagnostic IA qui lit la sauvegarde de votre robot, sans rien téléverser.

FANUC Alarm ISD-081 — %s high flow (ISD%d)

Description

The software has detected an excessively high flow level for the ISO/POLY material. This case is more severe than ISD-080, and may result in serious material application defects.

Remedy · Remède

The ISO/POLY flow rate has exceeded the "ISO/POLY Max Fault Flow" level for a period of time greater than the "Flow Lo/Hi Time Out" duration. Verify that the dispense equipment (pressure regulators, flow meters and spray modules, etc.) is functioning correctly. Verify that the settings on the Dispenser Setup screen are reasonable.

Related codes / Codes liés

ISD-074Spare dispenser stop (IPS%d)ISD-080%s high flow warn (ISD%d)ISD-082%s low flow warn (ISD%d)ISD-083%s low flow (ISD%d)

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. · Informations indicatives issues du terrain — le manuel du constructeur et ses procédures de sécurité font foi. Ne shuntez jamais un organe de sécurité ; consignez (LOTO) avant toute intervention physique.