LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free →

FANUC Alarm PAIN-495 — WARN Non-increasing cal table

Manufacturer wording — WARN (%s) Non-increasing cal table
The manual prints placeholders; your controller fills them in with the real group, axis or number.

FANUC PAIN-495 (“WARN Non-increasing cal table”): The IPC auto calibration aborted because the calibration table is not increasing with the commanded flow rate. First check: Ensure pumps are operating correctly.

Updated 2026-09-17 · LogrobotLM reference

Description

The IPC auto calibration aborted because the calibration table is not increasing with the commanded flow rate.

Remedy

Ensure pumps are operating correctly. Ensure that the speed command delay (used to allow the motor RPM to settle) is set to a sufficient amount.

Related codes

PAIN-493WARN Pump 2 totals differ > tolerancePAIN-494WARN …Calibration abortedPAIN-496WARN Zero PSIPAIN-497WARN Set Color Valve

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. How this reference is built →