LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free → · Le diagnostic IA qui lit la sauvegarde de votre robot, sans rien téléverser.

FANUC Alarm PAIN-505 — WARN %sCalibration aborted

Description

AccuAir calibration could not complete. This may be due to the air supply being off. Check for other alarms in the log. This may be due to incorrect setup parameters or incomplete hardware setup.

Remedy · Remède

The best may be found from the previous alarm in the log. Request a proper air flow at the cap, check that it occurs. Check that the Sensor scale and various other parameters are set properly. Increase the Calibration time out parameter.

Related codes / Codes liés

PAIN-503WARN %sFlow rate avg. error excessivePAIN-504WARN %sCalibration successfulPAIN-506WARN %sCal. low flow rate resetPAIN-507WARN %sCal. max. flow rate reset

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. · Informations indicatives issues du terrain — le manuel du constructeur et ses procédures de sécurité font foi. Ne shuntez jamais un organe de sécurité ; consignez (LOTO) avant toute intervention physique.