LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free →

FANUC Alarm PAIN-535 — WARN …Calibration aborted

Manufacturer wording — WARN %sCalibration aborted
The manual prints placeholders; your controller fills them in with the real group, axis or number.

FANUC PAIN-535 (“WARN …Calibration aborted”): AccuAir calibration could not complete. First check: The best may be found from the previous alarm in the log.

Updated 2026-09-17 · LogrobotLM reference

Description

AccuAir calibration could not complete. This may be due to the air supply being off. Check for other alarms in the log. This may be due to incorrect setup parameters or incomplete hardware setup.

Remedy

The best may be found from the previous alarm in the log. Request a proper air flow at the cap, check that it occurs. Check that the Sensor scale and various other parameters are set properly. Increase the Calibration time out parameter.

Related codes

PAIN-533WARN …Flow rate avg. error excessivePAIN-534WARN …Calibration successfulPAIN-536WARN …Cal. low flow rate resetPAIN-537WARN …Cal. max. flow rate reset

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. How this reference is built →