LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free →

FANUC Alarm PAIN-536 — WARN …Cal. low flow rate reset

Manufacturer wording — WARN %sCal. low flow rate reset
The manual prints placeholders; your controller fills them in with the real group, axis or number.

FANUC PAIN-536 (“WARN …Cal. low flow rate reset”): This is a warning not a failure. First check: The new flow rate is shown as point 2 in the calibration table.

Updated 2026-09-17 · LogrobotLM reference

Description

This is a warning not a failure. During AccuAir calibration the low flow rate could not be properly reached. A new flow was established. The target flow rate is determined by the Table point no. 2 parameter.

Remedy

The new flow rate is shown as point 2 in the calibration table. This value can be visually checked and accepted. Increase the yield of the system by increasing air line diameters to the applicator. The Table point no. 2 parameter can be increased (by about 100%).

Related codes

PAIN-534WARN …Calibration successfulPAIN-535WARN …Calibration abortedPAIN-537WARN …Cal. max. flow rate resetPAIN-538WARN …Cal. time out at max. flow

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. How this reference is built →