LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free →

FANUC Alarm PALL-144 — Visit layer spacing/flip menus

FANUC PALL-144 (“Visit layer spacing/flip menus”): Number of layers in the unit load was changed. First check: This is only a warning message to remind you to visit the layer flips and layer spacing menus to make sure that flips and spacing are correct for all the layers.

Updated 2026-09-17 · LogrobotLM reference

Description

Number of layers in the unit load was changed.

Remedy

This is only a warning message to remind you to visit the layer flips and layer spacing menus to make sure that flips and spacing are correct for all the layers.

Related codes

PALL-142Program not selectedPALL-143Data in use by RobotPALL-145PALL-146UOP Ignored. Wrong Start Mode

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. How this reference is built →