LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free →

FANUC Alarm PALL-228 — Unitload not recvd from PTPC …

Manufacturer wording — Unitload not recvd from PTPC %s
The manual prints placeholders; your controller fills them in with the real group, axis or number.

FANUC PALL-228 (“Unitload not recvd from PTPC …”): PTPC did not send the requested unitload data. First check: Check the MOTET communication and PTPC status.

Updated 2026-09-17 · LogrobotLM reference

Description

PTPC did not send the requested unitload data.

Remedy

Check the MOTET communication and PTPC status.

Related codes

PALL-226Invalid Gripper number from PTPC: …PALL-227Wrong unitload recvd from PTPC: …PALL-229Setup data not recvd from PTPCPALL-230using unitload NOT from PTPC

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. How this reference is built →