LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free →

FANUC Alarm PNT1-176 — Calculated output > Max Output

FANUC PNT1-176 (“Calculated output > Max Output”): The auto-calibration calculated the high flow output greater than the maximum output. First check: Look at the calibration results to determine if the maximum flow rate is acceptable.

Updated 2026-09-17 · LogrobotLM reference

Description

The auto-calibration calculated the high flow output greater than the maximum output. The cal table was saved with a lower range of flow than requested.

Remedy

Look at the calibration results to determine if the maximum flow rate is acceptable. If you do not need a higher flow rate then no additional action is required. If you need a higher flow rate then try the following

Related codes

PNT1-174Beaker Timeout, Scale Cal AbortedPNT1-175Non-increasing cal tablePNT1-177Calculated output < Min OutputPNT1-178Failed to reach setpoint

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. How this reference is built →