FANUC Alarm PNT1-618 — %sCal. low flow rate reset
FANUC PNT1-618 (“%sCal. low flow rate reset”): This is a warning not a failure. First check: The new flow rate is shown as point 2 in the calibration table.
Updated 2026-08-29 · LogrobotLM reference
Description
This is a warning not a failure. During AccuAir calibration the low flow rate could not be properly reached. A new flow rate was established. The target flow rate is determined by the Table point no. 2 parameter.
Remedy · Remède
The new flow rate is shown as point 2 in the calibration table. This value can be visually checked and accepted. Increase the yield of the system by increasing air line diameters to the applicator. The Table point no. 2 parameter can be increased (by about 100%).
Frequently asked · Questions fréquentes
- What does FANUC alarm PNT1-618 mean?
- FANUC PNT1-618 (“%sCal. low flow rate reset”): This is a warning not a failure. During AccuAir calibration the low flow rate could not be properly reached. A new flow rate was established. The target flow rate is determined by the Table point no. 2 parameter.
- How do you troubleshoot FANUC alarm PNT1-618?
- The new flow rate is shown as point 2 in the calibration table. This value can be visually checked and accepted. Increase the yield of the system by increasing air line diameters to the applicator. The Table point no. 2 parameter can be increased (by about 100%).
Related codes / Codes liés
Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. · Informations indicatives issues du terrain — le manuel du constructeur et ses procédures de sécurité font foi. Ne shuntez jamais un organe de sécurité ; consignez (LOTO) avant toute intervention physique. How this reference is built →