LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free → · Le diagnostic IA qui lit la sauvegarde de votre robot, sans rien téléverser.

FANUC Alarm PNT1-619 — %sCal. max. flow rate reset

Description

This is a warning, not a failure. During AccuAir calibration, the expected maximum flow rate could not be reached at the maximum output. A new maximum flow rate was established.

Remedy · Remède

The new maximum flow rate is shown as point 10 in the calibration table. This value can be visually checked, and accepted.

Related codes / Codes liés

PNT1-617%sCalibration abortedPNT1-618%sCal. low flow rate resetPNT1-620%sCal. time out at max. flowPNT1-621%sCal. time out at low flow

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. · Informations indicatives issues du terrain — le manuel du constructeur et ses procédures de sécurité font foi. Ne shuntez jamais un organe de sécurité ; consignez (LOTO) avant toute intervention physique.