LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free → · Le diagnostic IA qui lit la sauvegarde de votre robot, sans rien téléverser.

FANUC Alarm PNT1-699 — %sTurbine Startup Test Not Complete

FANUC PNT1-699 (“%sTurbine Startup Test Not Complete”): The Bell Speed Control Startup Test for the turbine is not complete. First check: Check the Start Mode field on the Bell Speed SETUP menu to check the status of the Startup Test.

Updated 2026-08-29 · LogrobotLM reference

Description

The Bell Speed Control Startup Test for the turbine is not complete. This test must be performed before running the turbine.

Remedy · Remède

Check the Start Mode field on the Bell Speed SETUP menu to check the status of the Startup Test. Then, run the test if necessary.

Frequently asked · Questions fréquentes

What does FANUC alarm PNT1-699 mean?
FANUC PNT1-699 (“%sTurbine Startup Test Not Complete”): The Bell Speed Control Startup Test for the turbine is not complete. This test must be performed before running the turbine.
How do you troubleshoot FANUC alarm PNT1-699?
Check the Start Mode field on the Bell Speed SETUP menu to check the status of the Startup Test. Then, run the test if necessary.

Related codes / Codes liés

PNT1-691%sEstat setpoint not reachedPNT1-692%sEstat T.P. enable TimeoutPNT1-700%sMax.dV/dT detectedPNT1-701%sMax. output has speed < setpoint

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. · Informations indicatives issues du terrain — le manuel du constructeur et ses procédures de sécurité font foi. Ne shuntez jamais un organe de sécurité ; consignez (LOTO) avant toute intervention physique. How this reference is built →