LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free → · Le diagnostic IA qui lit la sauvegarde de votre robot, sans rien téléverser.

FANUC Alarm SEAL-209 — WARN Nozzle over pressure (E%s)

Description

The problem is either the nozzle pressure is greater than setpoint for more than time limit or the upstream hose is ruptured and is leaking material.

Remedy · Remède

Use on-board diagnostics on the dispensing controller to verify that the nozzle pressure sensor is in order, replace sensor as required. Check for clog in gun or nozzle tip. If the problem is ruptured hose, replace hose

Related codes / Codes liés

SEAL-207WARN Bead defect detected (E%s)SEAL-208WARN Volume comp at max (E%s)SEAL-210WARN Nozzle under press (E%s)SEAL-211WARN Upstream over press (E%s)

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. · Informations indicatives issues du terrain — le manuel du constructeur et ses procédures de sécurité font foi. Ne shuntez jamais un organe de sécurité ; consignez (LOTO) avant toute intervention physique.