FANUC Alarm SPOT-190 — PAUSE Bad Pressure (EP=%s)-gun 2
FANUC SPOT-190 (“PAUSE Bad Pressure (EP=%s)-gun 2”): An inavlid binary equalization pressure was programmed in the teach pendant program. First check: Check the EP= value of the current line of the teach pendant program.
Updated 2026-08-29 · LogrobotLM reference
Description
An inavlid binary equalization pressure was programmed in the teach pendant program.
Remedy · Remède
Check the EP= value of the current line of the teach pendant program. The smallest valve pressure allowed is 0. For digital weld controllers, the largest pressure number allowed depends on the width of the Equalization Pressure group output. If this GOUT is 4 I/O points wide, then the max imum pressure is 15. If the GOUT is 5 I/O points wide, then the maximum pressure is 31. For serial weld controllers, the maximum pressure is 15. Re-program the EP= value in the teach pendant program.
Frequently asked · Questions fréquentes
- What does FANUC alarm SPOT-190 mean?
- FANUC SPOT-190 (“PAUSE Bad Pressure (EP=%s)-gun 2”): An inavlid binary equalization pressure was programmed in the teach pendant program.
- How do you troubleshoot FANUC alarm SPOT-190?
- Check the EP= value of the current line of the teach pendant program. The smallest valve pressure allowed is 0. For digital weld controllers, the largest pressure number allowed depends on the width of the Equalization Pressure group output. If this GOUT is 4 I/O points wide, then the max imum pressure is 15. If the…
Related codes / Codes liés
Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. · Informations indicatives issues du terrain — le manuel du constructeur et ses procédures de sécurité font foi. Ne shuntez jamais un organe de sécurité ; consignez (LOTO) avant toute intervention physique. How this reference is built →