LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free →

FANUC Alarm SPOT-216 — PAUSE Weld enable mismatch …-both guns

Manufacturer wording — PAUSE Weld enable mismatch %s-both guns
The manual prints placeholders; your controller fills them in with the real group, axis or number.

FANUC SPOT-216 (“PAUSE Weld enable mismatch …-both guns”): The weld enable status from the weld controller does not match the robot's weld enable status. First check: Check the robot's weld enable status on the TEST CYCLE menu and compare it to the weld controller's weld enable status.

Updated 2026-09-17 · LogrobotLM reference

Description

The weld enable status from the weld controller does not match the robot's weld enable status.

Remedy

Check the robot's weld enable status on the TEST CYCLE menu and compare it to the weld controller's weld enable status. These must be the same.

Related codes

SPOT-214PAUSE Water flow OK fault …-both gunsSPOT-215PAUSE X-former OK fault …-both gunsSPOT-217PAUSE Weld in process timeout …-both gunsSPOT-218PAUSE Weld complete timeout …-both guns

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. How this reference is built →