LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free →

FANUC Alarm SVGN-103 — Increased err. not set(Robot).

FANUC SVGN-103 (“Increased err. not set(Robot).”): Increased error limit for Robot(stationary) tip is set to 0.0mm First check: Set the Increased error to a value greater than 0.0mm if the Increased Error checking is needed.

Updated 2026-09-17 · LogrobotLM reference

Description

Increased error limit for Robot(stationary) tip is set to 0.0mm

Remedy

Set the Increased error to a value greater than 0.0mm if the Increased Error checking is needed. This item is set on the Tip Wear Detection screen (within the Servo Gun SETUP screen).

Related codes

SVGN-101Invalid position reg number.SVGN-102Increased err. not set(Gun).SVGN-104Excessive load detected.SVGN-105Failed to reset pulse coder.

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. How this reference is built →