LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free →

FANUC Alarm SVGN-122 — Pressure is not invertible.

FANUC SVGN-122 (“Pressure is not invertible.”): The specified pressure cannot be used, it does not lie on the calibration curve (2nd order). First check: Change the calibration method to the multi-linear segment method if possible.

Updated 2026-09-17 · LogrobotLM reference

Description

The specified pressure cannot be used, it does not lie on the calibration curve (2nd order).

Remedy

Change the calibration method to the multi-linear segment method if possible. Do this by setting the system variables $sgsyscfg.$cal_model = 12 and $sgsyscfg.$frc2spd_cnv = 3, then perform the pressure calibration again. Alternatively, perform pressure calibration again, or reduce max pressure.

Related codes

SVGN-119Max wear exceeded (Rbt Tip).SVGN-120Skipped max gun torque update: Gun….SVGN-123Over-torque protection disabled.SVGN-124Max gun torque must be > floor.

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. How this reference is built →