LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free →

KUKA Error 1336 — COR ONLY FOR DATA FILES

Displayed as KSS01336 on KRC4 / KRC5 controllers

KUKA 1336 (“COR ONLY FOR DATA FILES”): The command "COR" was used without a data list being selected. First check: Select the corresponding data list.

Updated 2026-09-09 · LogrobotLM reference

Cause

The command "COR" was used without a data list being selected. The command "COR" is only allowed for data lists.

Effect

The command is not processed.

Troubleshooting

Select the corresponding data list.

Related codes

1337TASK TOO COMPLEX1334MORE THAN 16 INTERRUPTS DEFINED1338BLOCK CANNOT BE CORRECTED1332RESET EXPECTED DUE TO A BLOCK SELECTION

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. How this reference is built →