KUKA Error 1434 — TARGET POINT NOT REACHED
Displayed as KSS01434 on KRC4 / KRC5 controllers
KUKA 1434 (“TARGET POINT NOT REACHED”): In the case of a block selection to CIRC blocks with a circle angle, the contour cannot be determined. First check: None.
Updated 2026-09-09 · LogrobotLM reference
Cause
In the case of a block selection to CIRC blocks with a circle angle, the contour cannot be determined. On Start, a LIN motion is executed to the programmed destination point.
Effect
The next motion is also a BCO run.
Troubleshooting
None.
Related codes
Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. How this reference is built →