ABB Error 133281 — Measurement system fault
ErrorABB 133281 (“Measurement system fault”): The SDI board (Servo Drive Interface) reports a measurement transmission failure on the serial link. Likely part: Measurement system (Measurement system).
Updated 2026-10-22 · LogrobotLM reference
What it means
The SDI board (Servo Drive Interface) reports a measurement transmission failure on the serial link.
What to check
- Check the cabinet internal communication ribbon cable and make sure the board is working.
- Note: Equivalent to the robot axis measurement transmission failures (38101).
Part to check / replace
ABB 133281 points to the hardware below — start here before ordering.
Tap a part for every code that points to it — and verify the exact variant for your controller before ordering.
Related codes
Same hardware involved
Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. How this reference is built →