LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free →

ABB Error 38105 — Data not found

Error

ABB 38105 (“Data not found”): Data not found: the measurement board configuration data cannot be found; the system starts with default values. Likely part: Carte de mesure (SMB) / Configuration (measurement board (SMB) / Configuration).

Updated 2026-10-22 · LogrobotLM reference

What it means

Data not found: the measurement board configuration data cannot be found; the system starts with default values.

What to check

  • Check the measurement system configuration (moc.cfg configuration files / Measurement Board parameters).
  • Reload the original configuration.
  • Check the identification of the connected SMB board.
  • Note: Configuration consistency error, often seen after replacing the SMB board or the axis computer.

Part to check / replace

ABB 38105 points to the hardware below — start here before ordering.

Tap a part for every code that points to it — and verify the exact variant for your controller before ordering.

Related codes

20032Revolution counter not updated20033Axis not synchronized38034Axis Computer / SMB / Serial measurement cable fault

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. How this reference is built →