LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free →

FANUC Alarm CVIS-298 — There is not TEMP memory to run DVM at this time.

FANUC CVIS-298 (“There is not TEMP memory to run DVM at this time.”): Diagnostic Video Monitoring (DVM) needs more TEMP memory than is currently available. First check: Reduce the number of pictures in the video loop.

Updated 2026-09-17 · LogrobotLM reference

Description

Diagnostic Video Monitoring (DVM) needs more TEMP memory than is currently available.

Remedy

Reduce the number of pictures in the video loop. If the state of the schedule becomes POWER UP, try cycling power on the robot. This might free up some memory.

Related codes

CVIS-296DVM internal error #….CVIS-297… specified for DVM event … cannot be accessed.CVIS-299Snap camera port … failed. Code ….CVIS-300The value of Light Output Signal Number … is out of range. The valid range is … to ….

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. How this reference is built →