LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free →

FANUC Alarm CVIS-299 — Snap camera port … failed. Code ….

Manufacturer wording — Snap camera port %d failed. Code %d.
The manual prints placeholders; your controller fills them in with the real group, axis or number.

FANUC CVIS-299 (“Snap camera port … failed. Code ….”): An error occured while acquiring an image from the camera. First check: Verify that there is acamera connected to the port.

Updated 2026-09-17 · LogrobotLM reference

Description

An error occured while acquiring an image from the camera.

Remedy

Verify that there is acamera connected to the port. If the connection looks OK, call the FANUC Hot-line and tell then the code number that is at the end.

Related codes

CVIS-297… specified for DVM event … cannot be accessed.CVIS-298There is not TEMP memory to run DVM at this time.CVIS-300The value of Light Output Signal Number … is out of range. The valid range is … to ….CVIS-301Edge pair is not selected. Select found item from results table.

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. How this reference is built →