LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free →

FANUC Alarm CVIS-345 — There are too few calibration points.

FANUC CVIS-345 (“There are too few calibration points.”): There are too few calibration points. First check: Add many calibration points.

Updated 2026-09-17 · LogrobotLM reference

Description

There are too few calibration points.

Remedy

Add many calibration points.

Related codes

CVIS-343Fail to initialize the cylinder calculation.CVIS-344The cylinder calculation did not converge.CVIS-346There are no target position.CVIS-347This configuration between camera and target is not supported.

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. How this reference is built →