FANUC Alarm CVIS-346 — There are no target position.

FANUC CVIS-346 (“There are no target position.”): There are no target position. First check: Train target position.

Updated 2026-09-17 · LogrobotLM reference

Description

There are no target position.

Remedy

Train target position.

Related codes

CVIS-344The cylinder calculation did not converge.CVIS-345There are too few calibration points.CVIS-347This configuration between camera and target is not supported.CVIS-348The camera that is connected to other controller is not supported.

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. How this reference is built →