LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free →

FANUC Alarm FRCE-162 — F/S temperature data overflow (F:…)

Manufacturer wording — F/S temperature data overflow (F:%d^1)
The manual prints placeholders; your controller fills them in with the real group, axis or number.

FANUC FRCE-162 (“F/S temperature data overflow (F:…)”): Temperature output error occurred in the sensor head. First check: 1. Move the robot to a safe pose. Likely part: Sensor head (Sensor head).

Updated 2026-09-17 · LogrobotLM reference

Description

Temperature output error occurred in the sensor head.

Remedy

1. Move the robot to a safe pose. 2. Turn the controller OFF, then ON again. If this alarm occurs again, go to the next step. 3. Replace the sensor head.

Part to check / replace

FANUC FRCE-162 points to the hardware below — start here before ordering.

Tap a part for every code that points to it — and verify the exact variant for your controller before ordering.

Related codes

FRCE-160F/S cable is cut (F:…)FRCE-161F/S timeout error (F:…)FRCE-163F/S watch dog error (F:…)FRCE-164F/S temp. lower limit error (F:…)

Same hardware involved

FRCE-156Sensor headFRCE-158Sensor headFRCE-165Sensor headFRCE-172Sensor head

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. How this reference is built →