LogrobotLM

LogrobotLM — AI fault diagnosis for ABB · KUKA · FANUC robots. It reads your robot backup in your browser (never uploaded) and pinpoints the fault. Try it free →

FANUC Alarm INTP-289 — PAUSE Can't save ffast point at program change

FANUC INTP-289 (“PAUSE Can't save ffast point at program change”): When fast fault is enabled, the program was paused at the part of program change First check: Check whether the CONT terminaton exists at end of sub-program If exist, please change it to FINE.

Updated 2026-09-17 · LogrobotLM reference

Description

When fast fault is enabled, the program was paused at the part of program change

Remedy

Check whether the CONT terminaton exists at end of sub-program If exist, please change it to FINE. This is the limitation of the fast fault recovery function.

Related codes

INTP-287PAUSE Fail to execute MAINT programINTP-288PAUSE Parameter does not existINTP-290PAUSE Fast fault recovery position is not savedINTP-291WARN Index for AR is not correct

Indicative field information — the robot manufacturer's manual and safety procedures always prevail. Never bypass a safety device; apply lockout/tagout (LOTO) before any physical intervention. How this reference is built →